DURALABEL PRO DRIVER

Loading Supply in the Rhino Cold Laminator. Then, try printing again. Once it stops, you can open the Toro and roll the label stock back in — making sure that the front edge of the label stock is going over the rubber roller near the front of the printer — or press Trim Label to cut off the extra supply and get a clean edge for your next label. Power was cycled too quickly. Have a question not answered yet? If you still see the same print quality problems, please contact our support team for help.

Uploader: Gazil
Date Added: 12 May 2007
File Size: 64.92 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 38435
Price: Free* [*Free Regsitration Required]

The Darkness setting may be too high. Instead, check Install a driver for another printer and click next.

DuraLabel PRO Information | Graphic Products

Getting Started with LabelForge. Check the Supply Loading Turn off the printer using the switch in the back, near the black power cord, and dufalabel the printer as if you were going to change all the supplies.

Operate the manual cutter by pressing down firmly on the lighter-colored actuator.

Cleaning the DuraLabel Toro. You should hear a click from each side, near the green tabs, as the latches catch. Read the fine print The DLP provides dots per inch of high-definition printing so that lines are sharper, small print is easier to read and images are more saturated than cheaper printers with dpi.

  LSI LOGIC 53C815 DRIVER

We can correct both problems very quickly. Open the printer and raise the print head mechanism, as if you were going to change all the supplies. It should be set to Thermal Transfer.

Then, try printing again. This will clear the internal memory and settings of the printer. This can happen by accident when supplies are changed, and is easy to resolve.

Remove any other rolls of durslabel stock from the area of the printer, and click the Clear Error button to clear the error furalabel and retry the print job. The printer is probably still showing an error from a previous printing attempt. If this does not resolve the problem, please contact our support team for help. Make sure the printing ribbon is passing above the black plastic ribbon sensor, and not blocking it from view.

Within five years of purchase and after proper application, Graphic Products will replace labels made with DuraLabel Premium Vinyl which become unreadable or fail to maintain adhesion with the labeled surface.

Printer Support – Drivers, Manuals & More | Graphic Products

Press Enter to accept the changed information, and then Enter again to accept changes to the Setup Menu. Turn the printer duralabl on and try printing your label again. How to Load DuraLabel Bronco. What issues are you running into?

  ACCIDENTALLY UNINSTALLED BLUETOOTH DRIVER

DURALABEL PRO 200 DRIVER DOWNLOAD

Dudalabel text box is being enlarged by dragging a corner handlebar while pressing the Shift Key. At that point, turn off the printer, give it about ten seconds, and turn it back on again.

If the error returns, continue to Step 2. If needed, correct this selection, and click OK to save changes and close this window. Skip to main content. Click on the printer icon in the taskbar at the top of the Toro home screen. We’ll guide you to the solution.

Under Advancedclick the Driver button to open the detailed controls. Try to print a few labels.

DuraLabel PRO 300

Click the button for Supply Update, in the lower-left corner of this window, and Toro will re-detect the label stock. Replace the cutting mechanism, inserting the tabs on the sides of the cutter, into the slots as shown below. Go to the Ports tab, and look for the port that is currently selected in that list.