MSI 6741 DRIVER

Mic is a connector for microphones. The gold arrow should point towards the lever pivot. Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board. When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating. You can attach a serial mouse or other serial devices directly to the connector.

Uploader: Zulubei
Date Added: 22 February 2005
File Size: 50.45 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 11558
Price: Free* [*Free Regsitration Required]

MS MOTHERBOARD | Emachines MS K8T Motherboard

It introduces a 66MHz, bit channel for the graphics controller to directly access main memory. Then push it in until the golden finger on the memory module is deeply inserted in the socket. If the CPU is correctly installed, the pins should be completely embedded into the socket and can not be seen. Mount the fan on top of the heatsink. You can clear CMOS by shorting pin while the system is off.

Pull the lever sideways away from the socket. Meanwhile, read the documentation for the expansion card to make any necessary hardware or software settings for the expansion card, such as jumpers, switches or BIOS configuration. The plastic clip at each side of the DIMM slot will automatically close.

You can plug the USB device directly into the connector. Locate the CPU and its retention mechanism on the motherboard. Avoid clearing the CMOS while the system is mso it will damage the mainboard.

  MOBILITY RADEON X2300 UBUNTU DRIVER

The connector location and pin assignments are as follows: You can barely see the golden finger if the module is 641 inserted in the socket. AGP is an interface specification designed for the throughput demands of 3D graphics. Overheating Overheating will seriously damage the CPU and system, always make sure the cooling fan can work properly to protect the CPU from overheating.

Floppy Disk Drive Connector: Each lever can be pressed down in only ONE direction.

Position the heatsink onto the retention mechanism. It’s a community-based project which helps to repair anything. Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard. When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating.

Press the two levers down to fasten Press down the fan until its four clips get wedged in the holes of the retention mechanism. While doing the installation, be careful in holding the components and follow the installation procedures. As the CPU is likely to move while the lever is being closed, always close the lever with your fingers pressing tightly on top of the CPU to make sure the CPU is properly and completely embedded into the socket.

  GIGAPORT AG WINDOWS 7 DRIVER DOWNLOAD

Follow the instructions below to clear the data: You can attach a serial mouse or other serial devices directly to the connector. J9 Optional You can connect a joystick or game pad to jsi connector.

MSI Ms-6741 K8mm-ilsr Ver 1 Socket 754 Motherboard With BP

Always consult the vendors for proper CPU cooling fan. To connect to the ATX power supply, make sure the plug of the power supply is inserted in the proper orientation and the pins are aligned.

Please turn off the power and unplug the power cord before installing the CPU.

Make sure to raise the lever up to a 90degree angle. The gold arrow should point towards the lever pivot. You must configure second hard drive to Slave mode by setting the jumper accordingly. Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused.

Refer to the hard msu documentation supplied by hard disk vendors for jumper setting instructions.